bennett
New Member
Has anyone attached a SUCKIT DUST BOOT to a DWP611 on a carve king?
Posts: 35
|
Post by bennett on May 13, 2019 19:19:43 GMT
Hi, Trying to install a corner finder on my Carve King. I am trying to use the UGS plug in for probing. I keep getting several different errors about "streaming" and will not run. The original software was for a Mach3 machine and it didn't run either. Suggestions? ? Thanks.... Bennett
|
|
|
Post by ibohan on May 15, 2019 15:53:15 GMT
Can you go into more detail about what errors you're getting? How are you plugging the probe into the board?
|
|