|
Post by koenbro on Nov 10, 2019 16:03:32 GMT
I have pulled out my M3 from storage and want to use it again. Have downloaded the current grbl 1.1 and flushed it onto the Arduino, then downloaded the Universal G-code sender v 2.0, but in the upgrade shuffle, my original setup was lost, and now the system behaves erratically, For example it won't home,moves the z up normally, then drops it. The x and the y don't move at all. Can someone please post the firmware setup they have -- should be the same for all machines right out of factory, right? Thank you all.
|
|
|
Post by Bruce on Nov 10, 2019 23:07:26 GMT
M3 GRBL Factory Settings:
$0=10 (step pulse, usec) $1=255 (step idle delay, msec) $2=0 (step port invert mask:00000000) $3=0 (dir port invert mask:00000000) $4=0 (step enable invert, bool) $5=0 (limit pins invert, bool) $6=0 (probe pin invert, bool) $10=3 (status report mask:00000011) $11=0.010 (junction deviation, mm) $12=0.002 (arc tolerance, mm) $13=0 (report inches, bool) $20=0 (soft limits, bool) $21=0 (hard limits, bool) $22=1 (homing cycle, bool) $23=0 (homing dir invert mask:00000000) $24=25.000 (homing feed, mm/min) $25=600.000 (homing seek, mm/min) $26=244 (homing debounce, msec) $27=4.000 (homing pull-off, mm) $30 = 12000 (Maximum spindle speed, RPM) $31 = 0 (Minimum spindle speed, RPM) $32 = 0 (Laser-mode enable, boolean)
$100=40.000 (x, step/mm) $101=40.000 (y, step/mm) $102=80.000 (z, step/mm) $110=8000.000 (x max rate, mm/min) $111=8000.000 (y max rate, mm/min) $112=3000.000 (z max rate, mm/min) $120=250.000 (x accel, mm/sec^2) $121=250.000 (y accel, mm/sec^2) $122=250.000 (z accel, mm/sec^2) $130=264.000 (x max travel, mm) $131=264.000 (y max travel, mm) $132=69.000 (z max travel, mm)
|
|
|
Post by koenbro on Nov 11, 2019 12:59:56 GMT
You have no idea how much you helped me, thank you. Saved.
|
|