|
Post by wanabecarver on Nov 19, 2019 15:28:31 GMT
so the first time i plugged in my electronics after assembly my power supply started pulsing and the stepper motors were clicking. Derick suggested trying each individual motor control board at a time (after powering down) between them. i tried that and they all seemed to check out. i put all of them (the driver boards) back on, and then y and z stopped clicking but the x didn't work at all. today i tried again and all three axis seemed to be ok but when i try to jog them with ugs they just click and two lights start blinking on my aduino board. I NEED HELP!!!!
|
|
|
Post by Derek the Admin on Nov 21, 2019 3:38:44 GMT
Gotcha via email.
|
|