|
|
Post by Derek the Admin on Mar 20, 2018 0:20:46 GMT
What Notso said. Also can you quantity this please. If you command a 5mm move how far does it move? Settings look good.
|
|
n8
New Member
Posts: 21 
|
Post by n8 on Mar 20, 2018 0:50:03 GMT
When I command it to move 5 mm, it moves 40
|
|
n8
New Member
Posts: 21
|
Post by n8 on Mar 20, 2018 0:52:10 GMT
Just noticed I forgot to move those. Will respond when I have replaced them.
|
|
n8
New Member
Posts: 21
|
Post by n8 on Mar 20, 2018 1:02:30 GMT
So I put the jumpers back in and now the motors are not moving in unison again. The one connected to the A is now moving 1/4 of a turn on a 1 mm command and the one connected to the Y is moving 1/8 of a turn
|
|
|
|
Post by notso on Mar 20, 2018 1:14:09 GMT
switch the chip A with Y and see if it follows the chip or stays with the motor....
This should tell you where the problem is. Stays with motor, then that's the problem, moves to the other motor then it is the chip...
|
|
n8
New Member
Posts: 21
|
Post by n8 on Mar 20, 2018 3:00:50 GMT
Replaced all 4 stepper drivers and I'm back in business! Thank you notso and Derek for all of your support.
|
|
