|
Post by Derek the Admin on Jan 15, 2019 15:57:13 GMT
Here's a copy that may be clearner. MillRight M3 Assembly - Homing Wiring Instr....pdf (115.37 KB) You don't need a ferrule crimper. Those PA-09 crimpers are the wrong tool for the job in my opinion. We have a set of those here but use them for dupont connectors, not for crimping other connectors. The PA-09 is more specifically for that one job. You want just general crimpers.
|
|
|
Post by nathanskidmore on Jan 17, 2019 5:52:22 GMT
I'm really struggling troubleshooting a non-working Z homing switch. Any ideas?
So far I've tried: 1. Testing continuity at the homing switch with no cables attached = works (AKA reading goes from 1 to near zero) 2. Testing continuity at the homing switch with cables attached = works 3. Testing continuity at the end of Z switch wires = works
4. Plugging Z switch wires into the X or Y switch pins on CNC shield = works! 5. Replacing CNC shield = still not working! 6. Replaced spade connectors and retested = not working 7. Tried other software = hard to tell, but seemed not working.
|
|
|
Post by Derek the Admin on Jan 17, 2019 12:00:00 GMT
If you have a certain version of Grbl firmware you might need to plug it in to SpEn. It’s a few rows down.
|
|
|
Post by nathanskidmore on Jan 17, 2019 14:49:24 GMT
WOW - that was it! Thank you! I never would have figured that out otherwise.
|
|
|
Post by jennamike on Jan 20, 2019 19:11:40 GMT
I had issues woth x axis homing on latest grbl and went back to the older version and homing worked fine
|
|