TwistedCNC
New Member
Enter your message here...
Posts: 12
Location: Fort Worth, Texas
Machine: Carve King
|
Post by TwistedCNC on Feb 26, 2020 16:02:00 GMT
Hey guys! I am still new here. I have cut some things and done some photo v-carving. Having a lot of fun learning and experimenting. Here is a youtube link ( youtu.be/OVW5DMQgTEQ ) and I want to know if any of you have any idea how he does it. He mentions in the comments that he uses Inkscape. I would love to figure out how to do this!! Let me know! Thanks y’all
|
|
|
Post by linkreincarnate on Feb 26, 2020 19:06:38 GMT
Photo V Carve. Then he fills with resin. Then after the resin has dried he thins the board so the light can shine through.
|
|
|
Post by Bruce on Feb 27, 2020 4:33:49 GMT
|
|
TwistedCNC
New Member
Enter your message here...
Posts: 12
Location: Fort Worth, Texas
Machine: Carve King
|
Post by TwistedCNC on Feb 29, 2020 17:42:33 GMT
I have photo vcarve but I dont get the results this guy gets. I was watching the video and I dont see a v-bit. It looks like a straight bit.
I have tried the halftoner, but the photo vcarve works better for me. but I dont get the results this guy does.
Thanks for the feedback guys.
|
|