|
Post by aatallah on Mar 29, 2020 6:29:05 GMT
Hello,
Am following the video tutorial for the Mega V XL Assembly, and the video person mentions that the length of the motor wires will be mentioned in the comments. Except there are no "comments below".
Where can I find the info about which motor wire length goes to which axis? I got the XL model.
Thanks!!! Antoine
|
|
jv
New Member
Posts: 49
|
Post by jv on Mar 29, 2020 17:30:58 GMT
I short wire goes to the side of the machine you plan on putting the controller on for the Y axis. So the left y axis will have the short wire length if the controller is installed on a left and the longer wire for the right Y axis. The motors are marked in millimeters for the wire length.
|
|
chadb
New Member
Posts: 2
|
Post by chadb on Mar 30, 2020 23:51:07 GMT
The card at the beginning of that segment had the motor lengths for each axis/size. I too spent some time trying to find it after it was mentioned in the video.
|
|
|
Post by aatallah on Mar 31, 2020 4:41:57 GMT
Haha, yup, figured it out, thanks! I think it's confusing only because he says it will be in the comments, I should have paid attention to the segment's card.
|
|
|
Post by aatallah on Apr 1, 2020 7:27:50 GMT
BTW Did my first few cuttings with the machine (few PCBs for an LED lighting setup), and WOW!! Absolutely fantastic. Great job Mill Right!!!!
|
|
|
Post by Bruce on Apr 3, 2020 3:30:06 GMT
Congrats on your new Mega V build.
|
|