|
|
Post by Bruce on May 13, 2020 17:03:48 GMT
Congrats on finding the problem. 👍
|
|
|
|
Post by cncnoob on May 15, 2020 2:22:06 GMT
As far as jogging goes, my issue turned out to be that the feed rate on the controller was set too low for the movement to be seen. I switched it from 10 to 110 and it jogs fine now. The homing issues were due to the top screw being loose on the coupler connecting the Z screw to the Z motor. Once I tightened it and turned the feed rate up everything works fine for the most part other than a lot of operator error.
|
|
|
|
Post by trialnterror on May 16, 2020 16:58:35 GMT
Does anyone know the reset command? And how to turn to inches from metric so I know what I’m looking at in movement? I can’t visualize mm
|
|
|
|
Post by devmach on May 16, 2020 17:05:53 GMT
Here is a list of Grbl commands: github.com/gnea/grbl/wiki/Grbl-v1.1-CommandsG20 should change you to imperial units. (There should be a toggle button in the jog control area of UGS). I think Ctrl-x is the soft reset command. |
|
|
|
Post by Bruce on May 17, 2020 22:53:00 GMT
Grbl v1.1 Configuration: github.com/gnea/grbl/wiki/Grbl-v1.1-ConfigurationTo change a setting just type in the consol: $13=1 (Report inches, boolean) to display the position in inches in UGS. Then make sure you have G20 in your G-code file to tell the machine your CAD/CAM is setup using inches. |
|
|
|
Post by trialnterror on May 21, 2020 12:05:56 GMT
Grbl v1.1 Configuration: github.com/gnea/grbl/wiki/Grbl-v1.1-ConfigurationTo change a setting just type in the consol: $13=1 (Report inches, boolean) to display the position in inches in UGS. Then make sure you have G20 in your G-code file to tell the machine your CAD/CAM is setup using inches. To reset the settings I used $RST=$ which is what I was looking for! And I found how to switch to inches. One other thing I need to figure out is when I try to use the probe for x and y it rapids very fast! I need to figure out how to slow that way..... down! |
|
|
|
Post by Bruce on May 22, 2020 1:47:12 GMT
Assuming you are using UGS, here is the setup for the probe function.
|
|
|
|
Post by btreichel on May 22, 2020 4:32:21 GMT
Have you trired that with the millright 4th axis UGS? I had to write my owm macro to make it work.
|
|
