|
Post by cncnoob on May 16, 2020 19:36:18 GMT
Has anyone else had problems with UGS stopping mid job? It still shows everything that that's already been completed in the visualizer, but it shows that the router has returned to the 0 position when it has not, and it will not allow me to resend the file or cancel it (it times out every time I try to cancel the file transfer without exception) unless I shut everything down and restart from the very beginning. Other than when it times out while trying to cancel, it doesn't show any errors.
|
|
|
Post by Bruce on May 17, 2020 23:04:04 GMT
This sound like you're losing the USB serial connection between the PC and the control. It usually occurs at totally random times. It might be the USB cable needs to be replaced with a better quality or you may have an issue with the USB hardware on your PC. Try using a different USB port or sometimes a USB hub with external power may help. If you have another PC you might try it and see if you get better results.
|
|
gofer
Junior Member
Posts: 86
|
Post by gofer on May 18, 2020 21:28:52 GMT
Go in to Control Panel - Hardware and Sound - Power Options - Change Plan Settings - On the next screen select Change advanced power settings - Click the + next to USB Settings - click the + next to USB selective suspend setting - make sure it is set to disabled - Click Apply then OK - this will prevent the USB connection from turning itself off.
|
|