|
Post by myfingersarecold on Jun 14, 2020 2:31:06 GMT
So I would like to put a wasteboard/spoilboard on my M3 without losing any z travel, so I was curious if there was a PDF with dimensions of the hole layout for the bed so I could make a new bed out of aluminum thinner than the starboard that came with my machine so I attach a wasteboard that I can then face so it's level without losing z travel (and maybe gaining a few mm in the process)
|
|
|
Post by Bruce on Jun 22, 2020 3:32:41 GMT
It may be easier to just install a whole new MDF waste board. You can buy a replacement from the MillRight store.
|
|
|
Post by myfingersarecold on Jun 25, 2020 0:49:22 GMT
It may be easier to just install a whole new MDF waste board. You can buy a replacement from the MillRight store. yeah. maybe ill buy one and trace the holes out onto a piece of aluminum and then i can cut up the MDF and face it so its flat relative to the CNC.
|
|