Power Route Assembly. How does gantry connect?

[tonybarnhill]

On page 24 of the manual, it states:

"Put one M5x20 screw in each linear bearing, just to hold the gantry for now."

There is no further mention in the manual about connecting the gantry. I can see in one of the pictures that there are screws in the holes, but there's nothing telling me how those screws got there and what length to use.

An M5x20 doesn't reach the hole, so the entire gantry is just sitting there right now. 

Thanks for your help,

Tony

[Bruce]

Did you get this figured out? You might check the Video instruction also: millrightcnc.com/resources/