|
Post by electrictermite on Jul 2, 2020 23:31:22 GMT
got a z probe and hooked it up, all works good. question is do you set your plunge for probe thickness so when you create your tool path all you have to do is run the z probe and then run your tool path so it will plunge to the work surface or do you after running z probe jog down your z the thickness of probe which will give you surface before running tool path operation..thats not having plunge for probe thickness figured already in your tool path. i can not find any vid on z probe tool change. i was using the paper method but wanted to switch to z probe.
|
|
|
Post by btreichel on Jul 2, 2020 23:41:23 GMT
|
|
|
Post by electrictermite on Jul 3, 2020 11:26:01 GMT
working great now, thank you.
|
|