markj
New Member
Posts: 11 
|
Post by markj on Jul 3, 2020 23:52:46 GMT
Hello everyone, I have a Carve King and using Aspire. I am running into trouble just cutting out a 3x6 piece. I started roughly with 3.5 x 6.5 piece and only getting a 3.125x6.125. In Aspire, I am doing a basic profile cut, cutting on the outside the 3x6 parameter. I trying to figure out if it is my cnc or if something is going on with aspire. I am centering my work in the middle of my piece, I have done this with other projects before and have not had a problems. Is there any adjustments I need to make on my cnc to keep it accuracy. If you guys have any ideas it would greatly be appreciated.
|
|
oldtech
Full Member
Posts: 222
Machine: Power Route
|
Post by oldtech on Jul 4, 2020 0:13:42 GMT
What size bit are you using and what size bit size are you telling Aspire to use?
|
|
markj
New Member
Posts: 11
|
Post by markj on Jul 4, 2020 1:19:09 GMT
I am using a flat 1/4" end mill. I selected a flat 1/4" end mill in aspire.
|
|
oldtech
Full Member
Posts: 222
Machine: Power Route
|
Post by oldtech on Jul 4, 2020 1:36:42 GMT
The reason I asked is that it's curious that each side is leaving 1/16". So it may be a parameter setting in Aspire. In fusion 360, you have the option to leave stock for a later finishing pass. Does Aspire have that option?
|
|
