mbnaso
Junior Member
Posts: 74
|
Post by mbnaso on Jul 5, 2020 1:13:59 GMT
Here is a link to my fusion 360 manufacture page showing my settings a360.co/3itiAxT. I open UGS load the file and zeroed it out to point centered on the aluminum. First try it dove into the aluminum and bored a hole. I made the slot wider (7 mil) to try to use a larger Diameter end mill but I could not contour it with a 1/4 inch bit. It kept saying no tool path. I changed back to a ball end 1/8 end mil. IT drilled down a bit then lifted up and started to run from too high but was cutting the slot then it suddenly drilled down and snapped my 1/8 flat end mill. I am pretty lost at this point. Why is it that the only tool I can carve with is either the 1/8 flat or ball end mils? These operations contour, pocket, or slot.
|
|