larrybird
New Member
Enter your message here...
Posts: 8
|
Post by larrybird on Dec 23, 2020 23:01:51 GMT
I think the M3 has two sets of holes to screw the mount into. You can use either set upper or lower.
|
|
larrybird
New Member
Enter your message here...
Posts: 8
|
Post by larrybird on Dec 23, 2020 23:03:54 GMT
Bruce thank you. I can’t get the x limit switch to trip. All others do. Is the x limit in the front or rear? I have it in the front?? Thank you so much...
|
|
|
Post by Bruce on Dec 24, 2020 23:02:21 GMT
The limit switch should be mounted on the same plate as the motor. May need to bend the arm of the limit switch slightly so it will engage.
|
|
|
Post by steve23244 on Feb 10, 2021 0:49:34 GMT
I have a question. (I can't figure out how to post). What pins do you connect the limit switches to on the auduino shield? One wire comes from the com tab on the switch and one from the no tab on the switch. Where do those wires go on the shield?
|
|
|
Post by Bruce on Feb 10, 2021 5:07:30 GMT
Which machine do you have Steve?
|
|