danc
New Member
Posts: 4
|
Post by danc on Aug 6, 2020 6:08:34 GMT
I have the M3, it's been working fine for a year or so. Last time, plugging it in there was a faint pop and the power supply no longer showed a green light, the fan would no longer run but I was able to connect with usb and ugs. I replaced the power supply, now the fan works but I'm unable to connect by USB. There is a green light on the arduino when plugged in.
Please let me know any suggested troubleshooting steps to determine which electronics are damaged, or if there is anything else I should try.
Thanks in advance.
Dan
|
|
|
Post by Bruce on Aug 8, 2020 1:34:54 GMT
I'm guessing there is no holding torque on the motors when power is applied. (Should not be able to move the axis) Probably looking at a new CNC Shield and stepper drivers, maybe a new Uno board.
|
|