|
Post by blopresti on Aug 9, 2020 22:07:11 GMT
I am in the process of assembling my 19" standard Mega V and at the point where I am installing the drag chain supports to the gantry. The supports that came with my machine are longer than those pictured in the assembly video for this machine (about 23-5/8") and are drilled for three t-nuts instead of two. It isn't apparent to me that the longer drag chain supports will be a problem, but I did not want to find that out later in the assembly process and have to work backwards. Has anybody recently assembled their Mega V and found these longer drag chain supports? I am also concerned that if I install these with three t-nuts and 5mm bolts each that I will run out of hardware before I have completed the assembly.
Thanks
|
|
|
Post by Bruce on Aug 14, 2020 1:16:44 GMT
I would send an email to support@millrightcnc.com and check if what you have is an issue.
|
|
al
New Member
Posts: 1
|
Post by al on Sept 4, 2021 19:56:06 GMT
So are they the wrong drag chain supports? I got the same
|
|