|
Post by bowhntr7846 on Jun 29, 2017 20:53:36 GMT
In Easel when I set up the graphic that i'm gonna mill, any tool larger than that showed it would not cut it correctly. Do you think I could use a bigger endmill or ballmill to make this carving? If so any pointers or help on this would be greatly appreciated! Thank You
|
|
|
Post by aforww on Jun 29, 2017 21:25:17 GMT
In Easel when I set up the graphic that i'm gonna mill, any tool larger than that showed it would not cut it correctly. Do you think I could use a bigger endmill or ballmill to make this carving? If so any pointers or help on this would be greatly appreciated! Thank You If I'm not mistaken, Easel does two stage carving. So, you hog out the majority with a larger bit then the 2nd pass is a rest machining pass with the 1/32" bit.
|
|