seanc
New Member
Posts: 1
|
Post by seanc on Jun 18, 2021 2:22:59 GMT
My PR started to hit that hard limit on the z axis immediately after started the program when traveling to first vector. Anyone have any idea what the cause may be?
|
|
|
Post by adisadimekic on Jul 1, 2021 12:10:22 GMT
your clearance plane is too high ?
|
|
Todd_LOA
New Member
Posts: 4
Machine: Power Route
|
Post by Todd_LOA on Aug 7, 2021 21:27:39 GMT
this may be too late but i had the same problem. What I found was that in the G-Code right after the G54 line (on my file) there was a G0 Z10 line that was sending my Z-Axis up 10 inches into the limit switch immediately upon starting any program. Not sure what yours was. I manually edited this out to state G0 Z0.6 (which was my clearance height i designated in Fusion 360. This solved the problem. I then later found out about turning off G28 in post process and this problem stopped happening. hope this helps. this frustrated me for a while too.
|
|