|
Post by thansen1222 on Jun 19, 2021 20:02:22 GMT
I just got a new Mega V. It's assembled and ready to go. But I can not get any response to jog commands at all. I've tried on MAC and PC. I've tried with universal G Code Sender as well as with Easel Pro's jog commands.
When I plug in the USB using the MAC (which is a better, new computer than my PC which is a piece of junk) I get a very brief green light inside the control box. Both UGCS and Easel connect to the machine. They show the interfaces and jog controller. I can "jog" the machine and it acts on the interface like it's working. But the machine does not move or respond at all. No motor noise, no fans, nothing.
Any ideas?
Thanks... TH
|
|
|
Post by ifitzell on Jun 20, 2021 1:16:31 GMT
I was just having the same problem, and noticed that my power adapter seems to have died. there were lights in the box so I assumed it had power but the fan was not on... anyway finaly noticed the light on the converter was dark and played with it a bit. definitely FUBARed. worth checking
|
|