|
Post by justsomeguy on Aug 25, 2021 23:39:37 GMT
The router on my M3 plunges straight down thru everything... material, spoil board and main board when I hit the start button. I set up everything as I have done in the past when all was working correctly but now instead of starting the cutting... it plunges. The only difference is i switched to the MillRight UGS download, where I had been using NetBean 8.1 UGS, Can anyone tell me what is happening or what I need to do to correct this? I attached the beginning of the Gcode as it was downloaded from Fusion360... Thank you
(viperlitewingstif2)
(viperlitewingstif2)
(T1 D=1.587 CR=0 - ZMIN=-4.175 - flat end mill)
G90 G94
G17
G21
(When using Fusion 360 for Personal Use, the feedrate of)
(rapid moves is reduced to match the feedrate of cutting)
(moves, which can increase machining time. Unrestricted rapid)
(moves are available with a Fusion 360 Subscription.)
G28 G91 Z0
G90
(2D Contour1)
T1
S5000 M3
G54
M8
G0 X-0.071 Y-0.015
Z15
G1 Z5 F1000
Z3.3 F333.3
Z-1.929
X-0.063 Z-1.978 F1000
X-0.041 Y-0.016 Z-2.022
X-0.006 Z-2.057
X0.039 Y-0.017 Z-2.08
X0.088 Z-2.088
X0.246 Y-0.02
X0.295 Y-0.012
X0.34 Y0.01
X0.376 Y0.044
X0.399 Y0.088
X0.407 Y0.137
X0.409 Y0.256
X0.397 Y1.147
X0.361 Y2.025
X0.301 Y2.891
|
|