|
Post by jesusmartinez on Sept 1, 2021 16:56:56 GMT
Hello! Finally got around to setting up my machine. I cannot get the motors to move? I try to home the machine, and I get these errors:
[Error] An error was detected while sending '$H': (ALARM:9) Homing fail. Could not find limit switch within search distances. Try increasing max travel, decreasing pull-off distance, or check wiring. Streaming has been paused. [Error] Error while processing response <An error was detected while sending '$H': (ALARM:9) Homing fail. Could not find limit switch within search distances. Try increasing max travel, decreasing pull-off distance, or check wiring. Streaming has been paused.> [Error] Error while processing response <ok>: An unexpected command was completed by the controller. Grbl 1.1i MegaV 4 Axis Router ['$' for help]
I try to jog the machine as well, and it does not respond. Thank you for any help!
|
|
|
Post by jboyle on Dec 3, 2021 3:28:17 GMT
I’m also having this exact issue, as I’m computer illiterate and completely new to the cnc world any help on this matter would be appreciated
|
|
|
Post by Bruce on Dec 19, 2021 22:32:39 GMT
What machine do you have? typically the motors should lock in place when the stepper divers engage. Make sure the USB serial driver is set to the right port in Win10 or what ever operating system you are using on the PC.
|
|