aczeller
New Member
Posts: 6
Machine: Other
|
Post by aczeller on Sept 20, 2021 19:22:08 GMT
Hey guys,
I'm trying to use my z-probe (purchased from Millright of course) on my Mega V XL. I am using UGS and have the ofsets plugged into the probe module are of the UGS options window. I have it plugged into the correct port on the back of the control box and have the alligator clip attached directly to the bit. when I attempt to zero the machine, it touches the plate but continues to travel after it hits the plate. UGS then sends an Alarm code and locks the interface until it is cleared. I have searched far and wide on Google and seem to have trouble finding anyone else with this problem, let alone a solution for it. Everything I seem to come across shows different issues with the probe module and nothing that is like this scenario. Any ideas?
thanks!
|
|
|
Post by nhrouter on Sept 26, 2021 19:11:06 GMT
Been there, done that...broke several bits trying to get that to work (very colorful language ensued). So, I wrote my own macros for probing which work every time without issue now.
|
|