Post by drk on Aug 7, 2022 8:43:05 GMT
Hello,
I have the Xl machine (35 * 35)
I followed the video basics for using UGS. I previously used Candle with another machine.
I tested all the axis, and they work. I tested the Homing switches, they tripped as they should.
In the video it was mentioned to home the machine. Upon doing so the Z axis moved down, and then started to do the grind since no limit switches are located there. It didn't hit the bottom, and hit the switch immediately.
I tested again but this time I raised the Z axis to start almost to the top. It repeated the same thing, went to the bottom and then started grinding.
What am I doing wrong, or what is the issue?
This is as far as I got so far with this machine.
I have the Xl machine (35 * 35)
I followed the video basics for using UGS. I previously used Candle with another machine.
I tested all the axis, and they work. I tested the Homing switches, they tripped as they should.
In the video it was mentioned to home the machine. Upon doing so the Z axis moved down, and then started to do the grind since no limit switches are located there. It didn't hit the bottom, and hit the switch immediately.
I tested again but this time I raised the Z axis to start almost to the top. It repeated the same thing, went to the bottom and then started grinding.
What am I doing wrong, or what is the issue?
This is as far as I got so far with this machine.
