Bubba's Workshop
Full Member
Posts: 166
Location: Ludington, Michigan
Machine: M3
|
Post by Bubba's Workshop on May 6, 2018 22:36:54 GMT
Ok so I am trying to make a square cut out for my M3. I put in that I'm using a 12" x 12" board and want to cut out a 10" x 10" square. All looks good in carbide create...open file in UGS and get some weird error. this is the file ...I'm still in learn mode so if any code masters can look this over, It would much be appreciated. plus if you think there would be an easier way to achieve this i'm open for suggestions. Thanks in advance SQUARE.nc (19.24 KB) |
|
|
|
Post by Derek the Admin on May 6, 2018 23:17:53 GMT
I have never used Carbide Create so I can't be of specific assistance on that, but nothing is immediately alarming about the G Code. It doesn't perform any arcs but instead does linear interpolation I can see. That's not going to cause errors though. What specifically is the error?
|
|
Bubba's Workshop
Full Member
Posts: 166
Location: Ludington, Michigan
Machine: M3
|
Post by Bubba's Workshop on May 7, 2018 12:20:39 GMT
I will get a screen shot of the error today after work..thanks again
|
|
|
|
Post by Derek the Admin on May 7, 2018 12:24:23 GMT
No problem.
|
|
Bubba's Workshop
Full Member
Posts: 166
Location: Ludington, Michigan
Machine: M3
|
Post by Bubba's Workshop on May 8, 2018 0:31:22 GMT
this is the error, but i clicked ok then it ran just fine so who knows lol Attachment Deleted |
|
