|
Post by aquanub on Nov 18, 2018 4:25:12 GMT
Hey guys, Before when posting my gcode I was able to turn off 'useG28' in the options, however it seems to be gone now? I know I can manually delete it from the file, but I would like to find out what caused this? I went through and looked at some of the tutorials and it seems my post config is "Grbl / grbl" instead of generic grbl... not sure if it makes a diff as it all points to grbl.cps Any ideas?
|
|
|
Post by aquanub on Nov 18, 2018 20:51:28 GMT
So to update... apparently its the option "g28 safe retracts" not sure why the name changed but thats it
|
|
|
Post by Bruce on Nov 18, 2018 23:15:59 GMT
So you set to "No" from "Yes"?
|
|
freik
Full Member
"What did you buy the new CNC Router for?" "To make stuff for my CNC Router!"
Posts: 107
Location: Bellevue, WA
Machine: Power Route
|
Post by freik on Nov 19, 2018 2:02:09 GMT
No: Set G28 safe retracts to "No". There's also a regex to filter out certain commands in UGS, but I don't recall where that is at the moment. I've got that setup to filter out a few commands that it gets stuck on. Next time I'm out in my shop, I'll get the various regex's I've put together to keep my PR running without interruption.
-Kev
|
|
freik
Full Member
"What did you buy the new CNC Router for?" "To make stuff for my CNC Router!"
Posts: 107
Location: Bellevue, WA
Machine: Power Route
|
Post by freik on Nov 19, 2018 2:03:53 GMT
Oops: Regex is a programming nerd term. Regular expression. It's way of expressing a pattern of text.
|
|