Goliathan
Junior Member
Posts: 68
Machine: Carve King
|
Post by Goliathan on Nov 19, 2018 19:30:20 GMT
Can anyone say what the overall foootprint for the Carve King is? I like the available workspace but I have a small shop and not a great amount of room.
I know I could fit an M3, I just wish it had a bigger work area.
Does anyone have any creative solutions for setting up a machine such as this in a small area, or is a dedicated tabletop pretty much the only option?
Thanks!
|
|
|
|
Post by Hommer Woods on Nov 19, 2018 20:59:33 GMT
My shop is my garage so it still has to allow room for the car, etc. The CK is 24' wide and 25" deep at the base. When you allow for the motors it is 28" 28". You also need room for the electronics and probably a PC. My table is 24" x 48" and works well. Attachments:
|
|
|
|
Post by Bruce on Nov 20, 2018 4:17:34 GMT
|
|
Goliathan
Junior Member
Posts: 68
Machine: Carve King
|
Post by Goliathan on Nov 20, 2018 13:43:19 GMT
 That's amazing
The fires are burning now, I might be able to reorganize thing in the shop to get this to fit after all.
My wife is going to be really upset with me.
|
|
|
|
Post by Derek the Admin on Nov 20, 2018 22:43:56 GMT
That's amazing The fires are burning now, I might be able to reorganize thing in the shop to get this to fit after all. My wife is going to be really upset with me.
You just have to make sure that the first project is a present for her for the house. That's usually what I recommend to husbands who are facing the doghouse, lol. |
|
That's amazing