|
Post by scottacus on Nov 26, 2018 4:38:39 GMT
I'm attempting to run my Carve King for the first time using a Mac and the UGSPlatform 2.0 and I can't find a section to set the maximum line length to 70. There are no settings under "Tools" and the only Sender Options that I can find are under "Preferences" as shown here. Any ideas other than using a Windows machine? I can connect to the Carve King to jog the gantry and set/return to zero.
|
|
|
Post by scottacus on Nov 26, 2018 4:51:42 GMT
Finally found it after about 45 minutes of searching. It is hidden under Options/Controller Options/Command Length Processor where you can set the value from: { "commandLength": 50 }
to
{ "commandLength": 70 }
Not super obvious but now the machine happily runs its route!
|
|
rowiac
Full Member
Posts: 230
Location: California
Machine: M3
|
Post by rowiac on Nov 26, 2018 22:58:19 GMT
I ran into that same problem last week with UGSPlatform 2.0 on Windows. You solved it the same way I did.
I've also been playing around with the Linux version so I can use an old laptop to run my M3. It was already set to 70 from the beginning on that one.
|
|