can we connect a touching probe with GRBL? (carveking)

[tim]

i have a touch probe, but i'm not sure if our controller supports this.

what controller (version) does the carveKing have?

[Derek the Admin]

There have been a couple discussions on this one and some have set it up on the Carve King. The pin on the red board is not labelled probe, but it is connected to the probe pin on the Uno. Check out the search using just the term "probe" and it will come up.

[linkreincarnate]

www.instructables.com/id/Setup-a-Touch-Probe-With-a-Arduino-Cbc-Shield-and-/ This might help...