any way to turn off incremental jog

[dragonfly]

I did not look hard but did not see an on/off tab for incremental jog. just picked up a carve king. nice little machine. I do need a 4th axis please . using aspire & fusion 360 depending on the draw. both apps post nice. enough with the rambling. good to be here.  

[Bruce]

What are you using for your G-Code sender?

[Derek the Admin]

Hey. Do you mean that it is switching to G91 (incremental mode), or do you mean incremental versus continuous jog?

[dragonfly]

Dec 18, 2018 4:01:37 GMT Derek the Admin said:

Hey. Do you mean that it is switching to G91 (incremental mode), or do you mean incremental versus continuous jog?

Is there control software that I can free jog the machine. Push a button go until I let go. Like my Mazak machines

[Derek the Admin]

I'm not aware off hand of machines that do a continuous jog with this firmware. I feel like I've seen some before, but I don't venture far outside of UGS these days.

What kind of Mazaks are you running, just out of curiosity.

[dragonfly]

candle does but looks like its abandoned. very nice UI. see where I changed step to continuous. it does work with the machine. 

Attachments:

[dragonfly]

this is better yet GRBL and has continuous jog, full simulation, other goodys and you can add machines. ill adapt this.

Attachments:

[Bruce]

Interesting program, 3d simulation with g-code sender. If I need to jog I just set it to 1mm or 10mm and push the button several times until I get it were I want it. Can't press it too many times at 10mm. It might crash, and there's no way to stop it.

[dragonfly]

GRBLGRU runs the mill excellent. Full control of the machine incremental and continuous jog. Keyboard or arrows. Much faster load, zero and roll. Very nice UI. So Aspire + GRBLGRU and I'm good to go👍

[Bruce]

So you can run a simulation of the program and then switch to sender mode and send the G-code to the Arduino/CNC Shield?