Vise for CNC Carve King

[jsbiii]

I want to purchase a vise for my Carve King. I have looked online and there are many, many choices. I have a budget of around $100. The vise needs to be able to accommodate a width of at least 6 inches and maybe up to 8 inches.

I have read a lot of reviews but seeing as this is a board with active CNC users, I went straight to the source.

Thanks in advance for any help you can give. 

[Derek the Admin]

I don't think you are going to find a low profile vise of 6 to 8 inches wide for that price unfortunately. You could however buy two 4" drill press vises for about $40 and place them next to each other.

[Bruce]

This thread might have some helpful information.

millrightcnc.proboards.com/thread/1593/tiny-vise-syndrome

[stever]

I’m looking for one too and was going to go look at this one and make sure it had a low enough profile.
m.lowes.com/pd/DELTA-6-in-Quick-Release-Drill-Press-Vise/50159087?cm_mmc=SCE_PLA_ONLY-_-ToolsAndHardware-_-SosBenchTopStationaryTools-_-50159087:DELTA&CAWELAID=&kpid=50159087&CAGPSPN=pla&k_clickID=go_625664149_34614290590_111133302310_aud-299487635210:pla-436499242017_m_9011569&gclid=EAIaIQobChMI_I2Ilsmz3wIVlgOGCh1jVgvTEAQYBSABEgLOqPD_BwE

Or this one
www.grizzly.com/products/Grizzly-Drill-Press-Vise-6-/G5753