|
Post by electrictermite on Feb 16, 2019 16:23:36 GMT
i have just begun to use the cnc machine and the first effort was deeper cut on one end than the other. i check the board thickness and the pixel width on the bitmap pic. if anyone would like to try this and see if may machine is off some how please do and let me know. 10X3 FRONT.gcode (102.43 KB)
|
|
|
Post by joebob296 on Feb 17, 2019 3:49:19 GMT
I your specific axis parallel to your work piece?
|
|
|
Post by electrictermite on Feb 17, 2019 5:03:19 GMT
i took my digital caliper and measured the height on my rails at 3 points for each one and all is level distance from base to rail. i magnified my bitmap and counted pixel width at both ends and they matched. i will try different bitmap and make it into gcode and see if boths ends carve the same depth tomorrow. i looked at the top of my carve king rails thinking something like sawdust got into the top of the rails making the bearing wheels lift up at the end of the rail but no obstruction.
|
|
rowiac
Full Member
Posts: 230
Location: California
Machine: M3
|
Post by rowiac on Feb 17, 2019 19:31:18 GMT
How much deeper is it on one end than the other?
|
|