bennett
New Member
Has anyone attached a SUCKIT DUST BOOT to a DWP611 on a carve king?
Posts: 35
|
Post by bennett on Apr 21, 2019 18:59:02 GMT
Hi again, forgot to mention that i don't get any response on the UGS comments console when I trip the limit switches....?
|
|
|
|
Post by Bruce on Apr 21, 2019 23:36:43 GMT
All the motors should click once when you plug in the USB and then again once the USB/serial is connected in the UGS software. The holding torque on the motors should be enough to keep from turning the lead screw with your fingers. If your not seeing a response from the limit switches check the wiring on the +Z, +Y, +Z pins of the CNC Shield.
|
|
|
|
Post by Derek the Admin on Apr 22, 2019 3:19:20 GMT
Hi again, forgot to mention that i don't get any response on the UGS comments console when I trip the limit switches....? That isn't intended to happen because hard limits are turned off by default. If you have verbose output turned on you would expect to see the switch contact indicated at the end of the streaming string, however. |
|
