|
Post by wildbill9 on Apr 21, 2019 16:09:17 GMT
My Skinny 8mm spacers between stepper motor and end plate are going into the end plate when I tighten the screws. Am I able to get a couple M3 washers and put between the end plate and the skinny spacer? I had to remove my stepper motor cause the coupling was installed to far on the shaft.
|
|
|
Post by Bruce on Apr 22, 2019 0:06:56 GMT
Send an email to support@millright.com
|
|
|
Post by wildbill9 on Apr 23, 2019 0:00:48 GMT
Thanks for the response Bruce. I got it solved I used a small washer between the spacer and end plate. One side of plate is okay other side of the plate hole seems bigger. I am guessing the plates are punch out on a press.
|
|