dayna818
New Member
Posts: 13
Machine: M3
|
Post by dayna818 on Apr 24, 2019 15:20:29 GMT
My M3 machine runs great but the Z axis belt slowly slips off and makes me start over on projects. I was using a screwdriver to push the belt back into place but I know this will get old. Any help would be awesome, thanks.
|
|
rowiac
Full Member
Posts: 230
Location: California
Machine: M3
|
Post by rowiac on Apr 25, 2019 3:11:53 GMT
From a side view of the Z-axis mechanism, make sure the pulleys are all in line vertically as closely as possible. Work the mechanism back and worth several times to make sure the belt stays centered on the pulleys--disconnect the motor wires from the PCB first so you don't accidentally burn it out. The belt should not be slipping off.
|
|
|
Post by Derek the Admin on Apr 25, 2019 4:11:37 GMT
Rowiac is correct.
Thanks for sharing your knowledge, rowiac.
|
|