|
Post by heyyou on Apr 26, 2019 21:44:47 GMT
good day I am so new at all this CNC stuff. have set up my Carve King so far successful. So I had to get a computer that was better/faster. Question is, do I have to go back and unplug stepper motors
to get the cnc to
install driver on the new computer? as in the setup pdf page 29?
|
|
|
Post by Bruce on Apr 27, 2019 3:43:29 GMT
You can install the USB Serial driver for the Arduino with the steppers plugged into the drivers. Should be no problem.
|
|