Stoping a job

[fyddler]

I run everything in inches. I use G20 before setting my x/y job origin, I use g92x0x0z0 to set my x and y and z job origin, and then run the program (in UGS). If I hit the stop button, the units goes back to mm, and I loose my work origin. What am I doing wrong?

[fyddler]

Did a bit of research, apparently this is known behavior of UGS, and on Winder's 2.0 Milestone list.

github.com/winder/Universal-G-Code-Sender/issues/860

[Derek the Admin]

Please also add this to the UGS wishlist thread.... we are making some modifications to UGS as well and we'd like to capture things like this if we could.

Derek