|
Post by chrishondathebarber on Jun 21, 2019 2:07:31 GMT
Is it normal for the majority of the screws to be loose in the holes? I'm not half way finished with the setup but I'm noticing that most of the screws are loose and have room to maneuver. I'm not sure if I was sent the wrong size screws or what.
|
|
|
Post by Derek the Admin on Jun 21, 2019 22:36:01 GMT
Hey. Yes, it is completely normal. Without free fitment, there would be no room for adjustment and the screw itself would be hard to put it. There is only one screw on the M3 that is not have free fitment and is not threaded and that is the idler bearing mount for the M3 and that was just to prevent a tool change on the production router for one hole.
|
|