|
Post by oakfordhome on Jul 23, 2019 15:53:42 GMT
Is the M6x25 machine screw supposed to not fit in the appropriate hole without screwing it in? Most of the other holes on the frame were large enough for the screws to slide right through to be tightened up by a nut. However, this one seems to require screwing the screw through the MDF frame in order to get it through to the outside for mounting the idler assembly. This is in reference to the bottom section of page 23 M3 assembly instructions. Thanks!!
|
|
|
Post by Derek the Admin on Jul 23, 2019 17:04:28 GMT
You can just screw through it. We leave that hole 5.6mm wide to avoid a tool change.
|
|
|
Post by oakfordhome on Jul 23, 2019 17:08:30 GMT
Thank you!!
|
|
|
Post by Derek the Admin on Jul 24, 2019 0:55:28 GMT
Anytime.
|
|