|
Post by 1984christopher on Sept 6, 2019 1:50:05 GMT
Hey guys/ gals chris here I've been battling issue after issues, Derek you have been super helpful, not sure if you remember your support to me "also bruse the forum guru" I'm the guy with the motor issues, I recently got new motors and then had to get a new flashed uno from millright and tonight I had a chance to wire plug and test, basically I have gone through 3 motors and electronics are all out putting jog controls. Keep in mind I have yet to actually run a cutting pass, only dry runs. Since I have been testing I got new motors set them on the tabel and did the 8mm 1 revolution how ever I let the two motors touch wile entergised and one stopped working. First has any one heard of this and possibly explain why I'm going through motors like underpants, ha! Second, I'm convinced these motors are junk, Love the carve king but can any one help me to under stand what my next steps should be. Is there a more expensive bullet proof version of these? Thanks guys!
|
|
|
Post by Derek the Admin on Sept 8, 2019 5:28:04 GMT
Hey Chris. What motors are you using? Ours or something else off the shelf?
|
|
|
Post by Bruce on Sept 8, 2019 20:31:11 GMT
Every time I get energized wires crossed, nothing good ever happens to me either.
|
|