jms
Full Member
Posts: 168
|
Post by jms on Dec 15, 2019 1:37:36 GMT
Ok, hope i am not driving you all nuts....but i got java to install, now i hooked up comp to poeer route and it couldnt install all the drivers....i went thru the thread on this subject where there is a zip file to download, but is this file good for my power route, or is it for another machine? Maybe this file works on all the machines but i want to be sure. Also it said ...no ports found....maybe this gets corrected when all drivers are installed?
Thanks, Joe
|
|
|
|
Post by Derek the Admin on Dec 15, 2019 4:05:30 GMT
The drivers are for the Arduino board itself, which is the control board for all of our models. Did you install the drivers from the other thread? When you open UGS have you hit reload (in the top bar) before selecting the drop down menu?
It sounds like you just need the drivers though.
|
|
jms
Full Member
Posts: 168
|
Post by jms on Dec 15, 2019 13:55:41 GMT
Ok, I manually installed drivers and it works. Now when I do the jog in all axis' , hit limit switch, alarm lights up and it wont let me back off, even after closing UGS, reopen and alarm is still lit.
Joe
|
|
jms
Full Member
Posts: 168
|
Post by jms on Dec 15, 2019 17:08:54 GMT
I read instructions wrong, it says to touch limit switches by hand, not jog machine to switch, i will try that and then try homing.....to be continued...
joe
|
|
