|
Post by faircloth on Dec 16, 2019 0:07:20 GMT
All was well till I got a new laptop with Windows 10 and now I cant get UGS to open. Im getting the "cannot find Java 1.8 or higher" after I unzip the UGS files I just downloaded Java and restarted the computer, nothing. Anyone find the workaround to this issue? Thanks
|
|
gogogad
New Member
Posts: 44
Machine: Carve King
|
Post by gogogad on Dec 16, 2019 3:00:11 GMT
I hate to have to ask this, but you did install Java after downloading it? I have win 10 on a few computers running UGS. Which version of java did you install? Cause sadly there are a few.
|
|
|
Post by faircloth on Dec 17, 2019 3:07:43 GMT
Yes installed and even uninstalled it then installed again with the same error. I just posted to my network and ran my program from my old laptop and it was going fine till about 25% when the machine, NOT UGS, just stopped as if I lost power. The lines kept buzzing by in UGS but the machine wasnt reacting to them. I tried running the opp 3 times and each time it froze in the exact same spot.
|
|
oldtech
Full Member
Posts: 222
Machine: Power Route
|
Post by oldtech on Dec 17, 2019 3:43:28 GMT
I've seen this also. In one case the culprit was my shop vac so I moved it. In another it was was my small heater on a separate circuit, so I'm not using it. I've also had the control box freeze from time to time but powering off and on seems to fix it.
I'm running Windows 10 on my shop computer with both Bluetooth and wifi off. The internet is via cable.
|
|