bwest
New Member
Posts: 1
|
Post by bwest on Dec 28, 2019 3:11:00 GMT
I am just about done making my X-Carve. I don't see anywhere in the instructions which Y motor goes to which driver. There is a "Y" and "A" driver, but I don't see any diagrams showing me which Y motor goes to Y and which goes to A.
If I'm looking at the front of the machine, is the left Y motor A or Y on the board?
|
|
rcferguson
Full Member
Posts: 182
Machine: Carve King
|
Post by rcferguson on Dec 28, 2019 5:10:57 GMT
I am just about done making my X-Carve. I don't see anywhere in the instructions which Y motor goes to which driver. There is a "Y" and "A" driver, but I don't see any diagrams showing me which Y motor goes to Y and which goes to A. If I'm looking at the front of the machine, is the left Y motor A or Y on the board? Don't think it matters... A is just a repeater of Y. They both turn the same amount in the same direction. |
|
|
|
Post by Derek the Admin on Dec 29, 2019 3:12:20 GMT
RCFerguson is correct. The jumpers on the left side of the red board just clone the Y to the A.
|
|
