|
|
Post by dudecnc on Feb 27, 2020 13:18:49 GMT
Hi, I was looking at some of the tramming threads but am a bit unclear. I ran a level on my CK (it is about 2 months old). Everything looks level but the router is tilted clockwise slightly, what is the best way to level this out? Can I just loosen the bolts and adjust or can I adjust the eccentric spacers on the z? Can anyone give some suggestions thank you
|
|
|
|
Post by dudecnc on Feb 27, 2020 19:46:14 GMT
I figured it out, I loosened the bottom z plate brought the spindle down to where I could access the screws that hold the mount, I was able to adjust it and snug them down and reassemble. She is level now in case anyone runs into that issue
|
|
|
|
Post by activereality on Feb 27, 2020 22:05:15 GMT
I figured it out, I loosened the bottom z plate brought the spindle down to where I could access the screws that hold the mount, I was able to adjust it and snug them down and reassemble. She is level now in case anyone runs into that issue Hmm, after you loosened the spindle mount screws, what did you 'adjust'? The Right/Left lean? I had to use a bit of paper between the lower edge of the mount and Z-Plate to 'nod' the spindle backwards a bit. But i also did the same and just lowered the spindle all the way down to access the spindle mount. Glad to hear you got it ironed out! |
|
|
|
Post by dudecnc on Feb 27, 2020 23:20:16 GMT
I had just enough play that I was able to adjust and tighten up the screws which put it level
|
|
