transientmole
New Member
Posts: 5
Location: Princeton, IL
Machine: Other
|
Post by transientmole on May 24, 2022 2:36:32 GMT
I have been running a JTech 7W laser on my Carve King 2 for a year or so - I purchased the laser from JTech directly and wired it into the control board at the time and it works well.
I have recently purchased and built a Mega V XL, and want to use the laser on that....and the control box for the Mega has a pre-wired laser connector (4 pin female aircraft connector). Anyone have the pinout diagram which shows which pins from the laser are for which pins in the built in aircraft connector in the Mega V control box? I was hoping not to have to tear apart the whole box to see :-)
Thank you!
|
|
wolfspyre
New Member
Posts: 6
Location: Austin, TX
Machine: Other
|
Post by wolfspyre on Jun 19, 2022 19:09:06 GMT
I’m in something of the same boat, only I bought the entire kit and kaboodle from millright
My laser has a 2prong molex connector the top (latch side) black connects to pin 1 of the aircraft commector. The bottom (red) connects to pin 4 of the aircraft connector.
I’ve yet to get it working though, so……
|
|