Post by seth on Sept 7, 2023 5:40:12 GMT
Hi All,
Disclaimer: I'm new to CNC so my knowledge is limited.
Machine: Mega V XL
RPM: 16000
Feedrate: 3500 mmpm
Bit: 1/8" down cut
I was running a 2d pocket operation that was carving a round hole. While cutting the tool path would rotate counterclockwise and then suddenly rotate clockwise, causing a shuttering sound and causing an irregular shaped hole.
This video shows what was happening: photos.app.goo.gl/HgccFNKZZg23JLv89
Here's a picture of the hole at the end (The small inner hole is the messed up one): photos.app.goo.gl/mxFCkCZnSehESuiW6
Any thoughts on what could be going wrong here?
Disclaimer: I'm new to CNC so my knowledge is limited.
Machine: Mega V XL
RPM: 16000
Feedrate: 3500 mmpm
Bit: 1/8" down cut
I was running a 2d pocket operation that was carving a round hole. While cutting the tool path would rotate counterclockwise and then suddenly rotate clockwise, causing a shuttering sound and causing an irregular shaped hole.
This video shows what was happening: photos.app.goo.gl/HgccFNKZZg23JLv89
Here's a picture of the hole at the end (The small inner hole is the messed up one): photos.app.goo.gl/mxFCkCZnSehESuiW6
Any thoughts on what could be going wrong here?