|
Post by duaneb on Sept 20, 2023 15:13:01 GMT
Hi everyone. I finished the assemble on the Power Route Plus last night. What are people using for the Spoilboard? What size is it? Purchased a 1" cutter to surface it, but how do you set things up to surface it? What depth of cut do you take - initially and each step after that? How do you set that up in Fusion? Do you create the Spoilboard the size of the Spoilboard you plan to use, then mill it down in, what , 0.01 steps, for 0.500" total depth of cut. Stopping when it's flat?
Thanks for the info!
|
|
|
Post by dadof4 on Sept 20, 2023 17:47:11 GMT
Scribble on it all over with a pencil. Surface it in small increments until the scribble is gone. No need to go .5”.
|
|
|
Post by duaneb on Sept 20, 2023 20:06:06 GMT
Thanks for the tip. I'll give that a try.
|
|