seanm
New Member
Posts: 7
|
Post by seanm on Oct 17, 2023 21:11:00 GMT
Hi Everyone,
I am trying to decide on a place to mount an air blast for my power route plus with a dewalt router. Has anyone done this before or have suggestions?
I was thinking one of the threaded holes in the linear bearing housings but then realized that it will not travel in Z. The outer holes (in green plastic area) do not have threading and I figure it isnt a good idea to drill into those. Other options are to make a collar like the one for dust boot or 3D print an adapter. I was going to show spots in a picture but the forum is maxed out on attachment space....
For now i'll glue and zip tie it in place but that isnt a permanent solution.
Thanks!
|
|