|
Post by Bones M&E on Jan 21, 2018 6:17:44 GMT
I got brave and stuck a piece of wood in my new M3, after three weeks of fusion i finally figured out how to break the surface, so here it is, my latest creation, thingy box. Tomorrow I'll figure out how to make a couple tiny lids for the pockets, this is fun ... youtu.be/1JG4KxoQrFQ
|
|
|
Post by Derek the Admin on Jan 21, 2018 15:06:00 GMT
Good work. That’s a nice looking project.
|
|
|
Post by Bruce on Jan 21, 2018 15:43:14 GMT
Nice work, Bones. Don't forget to post the finished product.
|
|
|
Post by Bones M&E on Jan 21, 2018 18:49:31 GMT
Good work. That’s a nice looking project. Finally starting to get the hang of fusion, I have a few trials I want to test out in the next few days before any attempt at a real project, Question, is there a (free) program for doing 3d relief work, Artcam seems to be the go to program for relief work, just not looking to spend that much on the software till I'm a little more ready. Also, Thank you Derek for the speedy replacement power supply, You guys at Millright have the best customer service ... (period.). Very happy with my purchase and service. Few more test runs on some scrap wood.
|
|
ozzy
New Member
Posts: 3
|
Post by ozzy on Jan 21, 2018 19:21:02 GMT
Very cool Bones!
|
|