laks
Junior Member
Posts: 86
|
Post by laks on Jan 23, 2018 14:41:08 GMT
so what bit should i use to engrave this acrylic, i used 1mm 3 flutes end mill seems too big for it.
|
|
|
Post by Bruce on Jan 23, 2018 18:25:35 GMT
Depends on the overall size of your work piece and how tight the corner areas you need to mill.
|
|
laks
Junior Member
Posts: 86
|
Post by laks on Jan 24, 2018 3:01:48 GMT
Depends on the overall size of your work piece and how tight the corner areas you need to mill. thanks but which is good for acrylic: vbit engraving bit tapered end mill
|
|
|
Post by Bruce on Jan 24, 2018 4:38:23 GMT
If you're looking at doing a v-carving, typically you can use any size bit. If you're staring out, try it with all three bits you have and see which one you like. There is no right or wrong answer really. Most popular is a 90 deg. 1/2" vbit. But that my be to large for your project. I haven't worked with acrylic at all either. So take my opinion with a grain of salt. 😁
|
|
laks
Junior Member
Posts: 86
|
Post by laks on Jan 24, 2018 4:45:27 GMT
If you're looking at doing a v-carving, typically you can use any size bit. If you're staring out, try it with all three bits you have and see which one you like. There is no right or wrong answer really. Most popular is a 90 deg. 1/2" vbit. But that my be to large for your project. I haven't worked with acrylic at all either. So take my opinion with a grain of salt. 😁 haha thanks i will definitely try all and post the outcome good or bad 😆
|
|